Loading ...
Loading ...
Loading ...
4
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting
installation.Read and follow the instructions provided
withanytools listed here.
Tools needed
Parts supplied
Remove parts from package. Check that all parts are included.
Parts needed
Optional accessories
* For information on ordering, see the “Assistance or Service”
section.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■ It is the installer’s responsibility to comply with installation
clearances specied on the model/serial/rating plate.
Themodel/serial/rating plate is located inside the range
hoodon the left wall.
■ Range hood location should be away from strong draft
areas,such as windows, doors and strong heating vents.
■ Cabinet opening dimensions that are shown must be
used.Given dimensions provide minimum clearance.
Consultthe cooktop/range manufacturer installation
instructions before making any cutouts.
■ This range hood is recommended for use with cooktops
witha maximum total rating of 40,000 BTUs or less.
■ Grounded electrical outlet is required. See “Electrical
Requirements” section.
■ All openings in ceiling and wall where range hood will
beinstalled must be sealed.
■ These range hoods are factory set for non-vented
installations and require charcoal lters. See the
“Assistanceor Service” section for information
onorderingcharcoal lters.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title
24CFR, Part 328 (formerly the Federal Standard for Mobile
Home Construction and Safety, title 24, HUD, Part 280)
or whensuch standard is not applicable, the standard for
Manufactured Home Installation 1982 (Manufactured Home
Sites, Communities and Setups) ANSI A225.1/NFPA 501A,
orlatest edition, or with local codes.
Product Dimensions
Flat-blade
screwdriver
Drill with 1/8" (3 mm), 1/2" (13 mm),
and 1¹⁄₄" (3 cm) bits
Wire stripper
#2 Phillips
screwdriver
Pencil
#8-18 x 5/8"
(4.2 x 16 mm)
truss-head screws
#8-18 x 1"
(4.2 x 25 mm)
flat-head screws
Drywall
anchors
Mounting
brackets
UL listed/CSA
wire connectors
approved
UL listed/CSA
approved 1/2 " (13 mm)
strain relief
120 V, 75 W
maximum,
type E26
incandescent lamp
Charcoal
filter kit
Part Number
W10355450*
Power
cord kit
Part Number
W10355452*
Stainless steel
cleaner and
polish
Part Number
31462A*
1"
(2.5 cm)
4¹⁵⁄₁₆"
(12.5 cm)
6⁹⁄₁₆" (16.7 cm) or
9⁹⁄₁₆" (24.4 cm)
29¹⁵⁄₁₆" (76.0 cm)
or
35¹⁵⁄₁₆" (91.0 cm)
18⁵⁄₈"
(47.3 cm)
1¹⁄₂"
(3.8 cm)
9"
(22.9 cm)
2"
(5.1 cm)
⁷⁄₈"
(2.2 cm)
Loading ...
Loading ...
Loading ...