Loading ...
Loading ...
Loading ...
PAGE: 7 / 10
Tighten blades to blade brackets by
using blade screws and washers.
NOTE: Before installing blade
brackets to the motor, please
remove the plastic inserts.
Remove the motor screws and washers
from the motor assembly.
Secure blade brackets to the motor with
washers and motor screws.
Screw
Hanger Bracket
Washer
Canopy
Fig.11
Fig.12
Blade Screw
Washer
Blade Bracket
Blade
Fig.13
Motor Screw
Blade Bracket
Plastic Insert
Washer
Assembly without fan light
Make sure the lead wire of fan light
in switch box is sealed with a wire
connector exactly. Secure the switch
box cover into fan fixture set with the
switch box screws.
Note: To install the fan light, skip this
step and proceed to Fig.15.
Switch Box
Screw
Fig.14
Fan Light Installation:
Hex Nut
Washer
Switch Box
Cover
Plug
Fan Light
Threaded Pipe
Fig.15
Remove the plug from the switch box cover. Remove the nut and lock washer
from fan light. Attach the fan light to the switch box cover by threading the fan
light wires (black and white) and remove threaded pipe through the hole of
switch box cover and then secure them onto the switch box cover with nut &
lock washer. Be sure it is tight enough to prevent light kit from vibrating loose.
Note:The glass shades of light kit and fan switch chain should be
staggered to avoid the fan switch chain and glass shades from getting
stuck or scratched.
Remove the switch box cover screws
from the switch box cover first.
There are four hanger bracket screws
and lock washers.
Remove two screws and lock washers
from the hanger bracket (one from
each side) and loosen the other two
remaining screws. Align the "L shaped"
slots of the canopy with the two
remaining screws on the hanger bracket
and push the canopy upwards to engage
the slots and turn clockwise to lock in
place. Tighten the screws and install
the other two hanger bracket screws
and lock washers into the remaining
holes of the canopy and tighten.
220104
Loading ...
Loading ...
Loading ...