Loading ...
Loading ...
Loading ...
36 — PiPe Trades Pro™
KEYSTROKE DISPLAY
ALL CLEArEd
1. Enter Pipe Size:
6 STD SIZE 6 INCH
2. Change the default Welder’s Gap from 1/8” to 3/32”:
2 * GAP 0-3/32 INCH
3. Enter Offset:
2 4 OFST 24 INCH
4. Enter the advance:
2 (Advance) RUN 32 INCH
5. Enter the Roll and calculate the pipe length and unknown
bend angle:
1 (Roll) LNTH 42-1/16 INCH
CUT 35-1/4 INCH
TO 3-5/16 INCH
GAP 0-3/32 INCH
FIT° 40.46°
IARC 4-1/32 INCH
CARC 6-11/32 INCH
OARC 8-11/16 INCH
*Note: Setting welder's gap to 3/32 inch will temporarily set the
outputs to 1/32 fractional resolution. To keep outputs in their
current fractional resolution (default is 1/16) press once
after entering the welder's gap. For example, if you keep the
fractional resolution at 1/16, the outputs above for IARC would
be 4 inches, and CARC would be 6-3/8 inches.
The cut length for the pipe is 35 and 1/4 inches and bend angle
is 40.46°. Included in the outputs are the arc lengths to be used
to cut your butt weld elbow to the calculated bend angle. These
are inner arc length of 4 and 1/32 inches, center arc length of 6
and 11/32 inches, and outer arc length of 8 and 11/16 inches.
(cont'd)
Loading ...
Loading ...
Loading ...