Loading ...
Loading ...
Loading ...
2. Pull and remove the spool cover (2).
2
1
3
4
5
3. Remove the bump knob (3)
4. Remove any remaining line. Clean dirt and debris
from all parts.
5. Replace the spool (4) if it is worn or damaged.
6. Put the new spool in the spool housing (5).
NOTE
Make sure that the cutting line is in the slot on the
new spool, and is extended approximately 6" (15 cm)
before you install the new spool.
7. Put the ends of the cutting lines through the holes.
8. Extend the cutting line to release it from the guide
slot in the spool.
9. Put the bump knob onto the spool.
10. Push the tabs and install the spool cover onto the
spool housing.
11. Push the spool cover until it clicks into position.
10.4 INSTALL THE CUTTING LINE
NOTE
Do not put more than 15 feet of cutting line in at a
time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on
the trimmer head.
Spool
cover
Bump
head
Slots
3. Put the cutting line through the hole. Push the
cutting line until it exits the opposite hole.
11
English
EN
Loading ...
Loading ...
Loading ...