Loading ...
Loading ...
Loading ...
Problem Cause
The drive of the blades do not
engage.
The drive belt on the mower deck is loose.
The electromagnetic coupling contact is loose.
A fuse is blown. Refer to
Fuses on page 5
.
The transaxle leaks oil. The seals, housing or gaskets are damaged.
There is air in the hydraulic system.
The cutting result is unsatisfac-
tory.
The tire pressure is different on the right and left sides. Refer to
Tire
pressure on page 20
.
The blades are damaged.
The suspension of the cutting deck is not level.
The blades are blunt. Refer to
To examine the blades on page 22
.
The product is operated at too high forward or rearward speed. Refer to
To
get a good cutting result on page 15
.
The grass is long or wet. Refer to
To get a good cutting result on page 15
.
There is grass blockage in the cutting deck. Refer to
To clean the product
on page 18
.
Transportation, storage and disposal
Transportation
• The product is heavy and can cause crush
injuries. Be careful when you load it onto or off
a vehicle or trailer.
• Load the product in reverse on approved ramps
of a maximum operation angle of 10°. Do not lift
the product.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local
road traffic regulations before transportation of
the product in a trailer or on roads.
• Stop the fuel supply of the product.
• Lock the product with approved devices, such as
straps. Use tie-down points on the product. The
parking brake is not sufficient to lock the product
during transportation.
To tow the product
WARNING: Before you tow the
product, you must read and understand
the safety chapter. Refer to
Safety on
page 6
.
• Be careful when you tow the product.
• Operate the product slowly when you tow the
product.
• The breaking distance increases when you tow
the product. Make sure to decreases the speed
in time.
• For safe operation, do wide turns.
• Do not tow near ditches, open water, and other
dangerous areas.
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage.
If you keep fuel in the fuel tank for 30 days or
more, tacky particles can cause blockage. This has a
negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is
not necessary. If you use standard gasoline, do
not change to alkylate gasoline. This can cause
sensitive rubber parts to become hard. Add stabilizer
to the fuel in the tank or in the container used for
storage. Always use the mixing ratios given by the
manufacturer. Add the stabilizer and run the engine
for a minimum of 10 minutes.
WARNING: Do not keep the
product with fuel in the tank in an indoor
location or in locations with bad airflow.
Risk of fire if fuel fumes come near
open flames, sparks, or pilot lights in
for example boilers, hot water tanks and
clothes dryers.
2060 - 002 - 13.06.2023 27
Loading ...
Loading ...
Loading ...