Loading ...
Loading ...
Loading ...
To lubricate the cutting deck
spindles
1. Remove the footrest plate (A).
A
B
C
2. Lubricate the 3 cutting deck spindles (B) 2-3
strokes.
Note: Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
3. Lubricate the idler arm (C) 2-3 strokes.
Tightening torques
Engine crankshaft bolt 50 ft-lb / 68 Nm
Mandrel pulley nuts 17 ft-lb / 23 Nm
Idler pulley nuts 30 ft-lb / 40.6 Nm
Idler arm bushing nut 70 ft-lb / 95 Nm
Lug nuts 75 ft-lb / 102 Nm
Blade bolts 90 ft-lb / 122 Nm
Spark plug 16.6 ft-lb / 22.5 Nm
Troubleshooting
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem Cause
Engine does not start. The drive of the blades is engaged. Refer to
PTO (Power Take-Off) button
on page 4
.
Steering controls are not locked in the parking brake position.
The battery is too weak. Refer to
To charge the battery on page 19
.
There is dirt in the fuel line.
The shut-off valve of fuel supply is closed or in the incorrect position.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
2060 - 002 - 13.06.2023 25
Loading ...
Loading ...
Loading ...