Loading ...
Loading ...
Loading ...
page 4
5. Fan Assembly.
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the
downrod provided to use with an extended
downrod (sold separately). [If you wish to use the
downrod provided, please proceed to instructions
following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball and remove the pin and clip. Lower
hanging ball and remove stop pin. Slide hanging ball
off the original downrod, A, and slide it down the
longer downrod, B (the top of the downrod should
be noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into top
of extended downrod and raise hanging ball. Be sure
stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
WARNING: Failure to tighten set screw completely
could result in the fan becoming loose and possibly
falling.
set screw hole
set screw
hanging ball
stop pin
pin
clip
A
B
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
Loosen yoke set screws and nut at top of motor
housing. Remove pin and clip from downrod (if you
have not already done so). Slide downrod through
yoke cover and canopy.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the downrod.
Place downrod into the motor housing yoke and
re-insert pin and clip that were previously removed.
Tighten yoke set screws and nut securely. Lower
canopy to motor housing.
["Fan Assembly" continued on next page.]
yoke set screw
downrod
electrical wiring
clip
pin
canopy
yoke cover
Loading ...
Loading ...
Loading ...