Loading ...
Loading ...
Loading ...
HCC1010A/W, HCD1010A/W, HCC1410A/W, HCD1410A/W 21
Evaporator reassembly
Fig. 20
14. Install ceramic mating ring and shaft seal.
Caution: Do not touch the sealed surface of either
part. Oil from bare skin will cause premature seal
failure.
15. Use liquid hand soap on the rubber part of the
ceramic seal when installing in main housing. Use
supplied cardboard disc to press into recess.
16. Apply liquid hand soap to raised area of auger
shaft and interior rubber portion of shaft seal before
installing seal.
1 7. Clean O ring groove. Lubricate O ring with petrol-gel
and reinstall.
Cardboard
disc
Do NOT
touch!
Fig. 21
18. Carefully install auger.
19. Rotate auger to position shown to clear main housing
stream divider.
Fig. 22
20. Install rear shuttle insulation (Fig. 22.1) and slide
main housing (Fig. 22.2) onto auger.
2 1. When installing new water seal, use screwdriver to
compress the spring (Fig. 22.3), which allows for
easier installation of the three screws.
1
2
3
Loading ...
Loading ...
Loading ...