Napoleon PRO500RSIBNSS-3-GR

Manual - Page 90

For PRO500RSIBNSS-3-GR.

PDF File Manual, 129 pages, Read Online | Download pdf file

PRO500RSIBNSS-3-GR photo
Loading ...
Loading ...
Loading ...
17
EN
www.napoleon.com
N415-0518CE-GB-DE AUG 05.20
Problem Possible Causes Soluon



burner abruptly makes


blow-torch type sound
and grows dim.)

drippings and build-up. Ports are clogged.
Burner overheated due to inadequate

by griddle or pan.)

Leaking gasket surrounding the ceramic

housing.

minutes. Relight burner and burn on high for at

evenly glowing red.



minutes, then relight.
Allow burner to cool and inspect very closely

your authorized Napoleon dealer to order a
replacement burner assembly.
Contact your authorized Napoleon dealer for

assembly.
Pilot will not light.
(if equipped)
Lack of gas.


Dirty pilot electrode.
Pilot is actually lit.

approximately 20-30 seconds for air to purge
the gas supply line while pressing igniter. Fill



burner. This enables the gas to reach the valves
on the manifold more quickly.

Replace lead wire.
Clean pilot electrode.


cm) above grill surface over the pilot burner to
feel for heat.


when turn on the light
switch and the knob red

when turn on the gas
burners
The knob lights wire connector
disconnected from the main wire
connector



Connect the knob light wire connector to the
main wire connector inside of the control panel
Replace the light switch
Replace the wire harness of the control panel




does not work


Replace the ignitor switch if the switch light
illuminates when you turn the light switch on


when you turn it on
Replace the ignitor block if the ignitor switch




or rear burner even when
sparking noise occurs
The gap between electrodes is too big or
too small


ignite


The knob and switch lights

seconds intervals and then

 
Loading ...
Loading ...
Loading ...