Loading ...
Loading ...
Loading ...
19
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILL TANK Insucient water in the tank. Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
EMPTY GROUNDS CONTAINER The grounds container (A12) is full.
Empty the grounds container and drip tray,
clean and replace (g. 26).
Important: when removing the drip tray, the
grounds container MUST be emptied, even if it
contains few grounds.
If this is not done, when you make the next
coees, the grounds container may ll up more
than expected and clog the machine.
GROUND TOO FINE ADJUST
MILL
The grinding is too ne and the coee is delive-
red too slowly or not at all.
Repeat coee delivery and turn the grinding
adjustment dial (g. 13) one click clockwise to-
wards “7” while the coee mill is in operation.
If after making at least 2 coees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see the section:
“Adjusting the coee mill on page 12).
If
the problem persists, make sure the water tank
is fully inserted, press the button
and
deliver a little water from the spout.
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
been replaced.
Remove the drip tray and insert the grounds
container.
ADD PRE-GROUND COFFEE With the pre-ground function selected, pre-
ground coee has not been poured into the
funnel.
Place pre-ground coee in the funnel or dese-
lect the “pre-ground” function (g. 17).
DESCALE The machine must be descaled. The descaling procedure described in the section
“Descaling” needs to be performed as soon as
possible (page 16).
LESS COFFEE Too much coee has been used.
Select a milder taste by pressing the
button (g. 10) or reduce the quantity of pre-
ground coee.
FILL BEANS CONTAINER The coee beans have run out. Fill the beans container (g. 14).
The pre-ground coee funnel is clogged. Empty the funnel with the help of a brush as
described in the section “Cleaning the pre-
ground coee funnel” (page 15).
INSERT INFUSER ASSEMBLY The infuser has not been replaced after
cleaning.
Insert the infuser as described in the para-
graph “Cleaning the infuser” (page 15).
INSERT TANK The tank is not correctly in place. Insert the tank correctly and press as far as it
will go.
Loading ...
Loading ...