Loading ...
Loading ...
Loading ...
17
Measuring water hardness
1. Remove the “TOTAL HARDNESS TEST” indicator paper from
its pack (attached to the English instructions).
2. Immerse the paper completely in a glass of water for one
second.
3. Remove the paper from the water and shake lightly. After
about a minute, 1, 2, 3, or 4 red squares form, depending
on the hardness of the water. Each square corresponds to
one level.
Setting water hardness
1. Press the MENU/ESC button to enter the menu.
2. Press < or > to select “Water hardness”.
3. Press the button to conrm the selection.
4. Press < or > and set the hardness level as measured by the
indicator strip (see the g. in the previous paragraph).
5. Press the button to conrm the setting.
6. Press the MENU/ESC button to exit the menu.
The machine is now reprogrammed with the new water
hardness setting.
WATER SOFTENER FILTER
Certain models are tted with a water softener lter. If this is not
the case with your model, you are recommended to purchase
one from De’Longhi Customer Services. To use the lter correctly,
follow the instructions below.
Installing the lter
37
1. Remove the lter from
the packaging.
2. Turn the date indicator
disk (g. 37) until the
next two months of use
are displayed.
Please note
The lter lasts about two
months if the appliance is used
normally. If the coee machine
is left unused with the lter installed, it will last a maximum of
three weeks.
3. To activate the lter, run tap water through the hole in the
lter as shown in the gure until water comes out of the
openings at the side for more than a minute (g. 38).
3938
0,5 L
4. Extract the tank from the appliance and ll with water.
5. Insert the lter in the water tank and immerse it comple-
tely for about ten minutes, sloping it and pressing it lightly
to enable the air bubbles to escape (g. 39).
6. Insert the lter in the lter housing (g. 40A) and press as
far as it will go.
7. Close the tank with the lid (g. 40B), then put the tank
back in the machine.
40A 40B
When you install the lter, you must notify the appliance of its
presence.
8. Press the MENU/ESC button to enter the menu;
9. Press < or > (g. 9) until “Install lter” is displayed;
10. Press the button;
11. “Enable?” is displayed;
12. Press the button to conrm the selection. “HOT
WATER Press OK” is displayed.
13. Position a container under the hot water spout (min. capa-
city: 500 ml).
14. Press the button to conrm the selection. The ap-
pliance begins hot water delivery and the message “Please
wait” is displayed.
15. After delivery, the appliance is automatically ready to make the
next drink.
The new lter is active. You can now use the appliance.
Soft water
Slightly hard water
Hard water
Very hard water
Loading ...
Loading ...
Loading ...