Loading ...
Loading ...
Loading ...
15
Even if not full, the empty grounds container message is displa-
yed 72 hours after the rst coee has been prepared. For the
72 hours to be calculated correctly, the machine must never be
turned o using the main switch.
To clean (with the machine on):
• Extract the drip tray (g. 26), empty and clean.
• Empty the grounds container and clean thoroughly to re-
move all residues left on the bottom. This can be done with
the spatula on the brush provided.
• Check the condensate tray and empty if necessary (g. 27).
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds.
If this is not done, when you make the next coees, the grounds
container may ll up more than expected and clog the machine.
Cleaning the drip tray and condensate tray
Important!
The drip tray is tted with a level indicator (red) showing the
level of water it contains (g. 28).
Before the indicator protrudes from the cup tray, the drip tray
must be emptied and cleaned, otherwise the water may over-
ow the edge and damage the appliance, the surface it rests on
or the surrounding area.
To remove the drip tray:
1. Extract the drip tray and grounds container (g. 26);
2. Empty the drip tray and grounds container and wash them;
3. Check the condensate tray and empty if necessary.
4. Replace the drip tray complete with grounds container.
Cleaning the inside of the coee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned o
(see “Turning o”) and unplugged from the mains power sup-
ply. Never immerse the coee machine in water.
1. Check regularly (about once a week) that the inside of the
appliance (accessible after removing the drip tray) is not
dirty. If necessary, remove coee deposits with the brush
supplied and a sponge.
2. Remove the residues with a vacuum cleaner (g. 29).
Cleaning the water tank
1. Clean the water tank (A18) regularly (about once a month
and whenever you replace the water softener lter (if pre-
sent) with a damp cloth and a little mild washing up liquid.
2. Remove the lter (if present) and rinse with running water.
3. Replace the lter (if present), ll the tank with fresh water
and replace the tank.
Cleaning the coee spouts
1. Clean the coee spouts regularly with a sponge or cloth
(g. 30).
2. Check the holes in the coee spout are not blocked. If ne-
cessary, remove coee deposits with a toothpick (g. 30).
Cleaning the pre-ground coee funnel
Check regularly (about once a month ) that the pre-ground cof-
fee funnel (A4) is not blocked.
If necessary, remove coee deposits with the brush (D2)
supplied.
Cleaning the infuser
The infuser (A15) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see “Turning
o” on page 9).
2. Extract the water tank (g. 4).
3. Open the infuser door (g. 31) on the right side of the
appliance.
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (g. 32).
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C2) to remove any coee residues left in the
infuser housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 33), then push the PUSH symbol fully
in until it clicks into place.
33
Please note!
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 34.
Infuser
support
Loading ...
Loading ...
Loading ...