Loading ...
Loading ...
Loading ...
Installation
24
This appliance must be installed by an
authorised person in accordance with the
instruction manual, AS/NZS 5601 - Gas
installations (installation and pipe sizing),
local gas fitting regulations, local water
regulations, local electric regulations, local
health regulations, Building Code of
Australia and any government authority.
This appliance is suitable for connection
with rigid pipe or flexible hose. The isolating
manual shut-off valve connection point must
be accessible when the appliance is
installed.
Flexible hose assembly must be certified to
AS/NZS 1869 class B or D, be of
appropriate internal diameter for the total
gas consumption (10mm), be kept as short
as possible (not exceeding 1200mm), must
not be in contact with the floor or any hot
surface. The hose assembly must not be
subject to strain, abrasion, kinking,
deformation, contact with any other
appliance or accidental contact with oven
flue outlet of an under bench oven.
Natural Gas: the pressure regulator must
be fitted to the appliance inlet connection.
Gas pressure must be adjusted to 1.0 kPa
when approximately 50% of the burners are
on high flame, the appliance test point is
located on the regulator.
ULPG: the supplied test point adaptor must
be fitted to the appliance inlet connection.
Gas pressure must be checked to 2.75 kPa
when approximately 50% of the burners are
on high flame.
Gas leakage and operation of the
appliance must be tested by the installer
before leaving.
Check burner flames are blue in colour,
stable and completely ignite at both high
and low flame settings with no appreciable
yellow tipping, carbon deposition, lifting,
floating, lighting back or objectionable
odour.
Test burners individually and in
combination, when satisfied with the
operation of the cooker, please instruct the
user on the correct method of operation.
Room ventilation
The room containing the appliance should
have a permanent air supply in accordance
with the standards in force. The room where
the appliance is installed must have enough
air flow needed for the regular combustion
of gas and the necessary air change in the
room itself. The cooktop shall be installed in
rooms with natural ventilation, as required
by Standards regulations AS/NZS5601.
Combustion gas discharge
Combustion gases may be discharged by
means of hoods connected to a flue with
reliable natural draught, or a fan extraction
system. An effective extraction system
requires careful design by an authorised
specialist, and must comply with the
regulation distances and positions. After
installation, the engineer must issue a
certificate of compliance.
Loading ...
Loading ...
Loading ...