Loading ...
Loading ...
Loading ...
RiEhtFax 9/10/2003 10:38 PAGE 12/41 RightFax
• Additional abrasive discs are available (See Recommended
Accessories, pages 19 and 25).
• Replace dust cover and disc table.
ABRASIVE DRUM FINISHING
WARNING: Position the belt assembly to the horizontal
posiUon before using the drum, If the belt is in the vertical
position, it may be unintentionally contacted causing injury,
• Abrasive drum sanding is well suited for finishing small fiat
surfaces and small contoured work,pieces.
• Support worl<piece on the table. Hold workplece with both
hands and keep finger away from drum,
• Always sand against the rotation of the sanding drum.
• Using the oscillation feature will help reduce scoring the
weft<piece and protong life of the abrasive sleeve.
REPLACING DRUMS AND ABRASIVE SLEEVES
Refer to Figures 26 and 27.
WARNING: Disconnect sander from power source,
To install '/="sleeve:
• Remove knob from spindle, Knob has left hand thread,
• Place 'M" table insert into table
• Slide sleeve onto spindle
• Place 'W' drum washer ont_ spindle and secure with knob.
To install 1" sleeve,
• Remove knob from spindle. Knob had left hand thread.
• Place 1" table insert Into table
• S[ide sleeve over 1" drum Slide drum with sleeve onto
spindle
• Place 1" drum washer over drum and seCUre with knob.
Figure 27 - Install 1" Sleeve
USING MITER GAUGE
Referto Figure28.
• "Themiter gaugeIs used onboth belt and disctables.Use
the miter gaugeforsecuringtheworkand holdingthe
properangle whtieeendtng.
• Adjustangle by repostiloningthemiter gaugescaleand
lockingit Intoplace withknob.
• Checkaccuracyof mitergaugescala.
• Usea combination square to adjustmitergaugesquare to
disc.Indicatorshouldbe at zero.Loosenscrewand
reposttionIndicatorifnecessary.
Miter Gauge
WARNING: Make certain that the unit is disconnected from
power source before attempting to service or remove any
componenL
CLEANING
Keep machine and workshop clean. Do not allow sawdust to
accumulate on the tool. Keep the drums clean. Dirt on drums
will cause poor tracking and belt slippage. Operate tool with
dust cotiectlon bag instattad to keep dust from accumutat_ng
11
Loading ...
Loading ...
Loading ...