Loading ...
Loading ...
Loading ...
RightFax 9/10/2003 i0:38 PAGE ii/41 RightFax
ADJUSTING BELT TABLE
• TOadjust belt table angle, loosen bendta.
• Tilt belt table to desired position. Adjust for 'h6"maximum
clearance between the belt end the table. Secure by tJghto
ening handle.
Tre_ng NUt
ADJUSTING BELT ASSEMBLY POSITION
WARNING: Disconnectsanderfrom powersource,
• Loosensockethead boltthat [sthreaded Intopivotbracket.
• Tiltbelt assemblyto desiredposition(fromhodzontelto
vertical),Secure beltassemblypositionbytighteningsocket
head bolt In pivotbracket.
HORIZONTAL BELT SANDING
CAUTION: When the sandtagcenter Is mounted ona work-
bench, make sure the dust collection bag Is clear of the belt
assembly.
Refer to Figure 23.
• The belt platen can be tilted from a vertical to a horizontal
po.Sltlon.
• Remove the belt table by removing the handle arid locking
nuL Loosen the socket head bolt in the pivot bracket;,tilt the
belt platen assembly to the hodzental position and tighten
the socket head bolt to secure posiUoo.
• Idler roller can be used as a contact drum to sand surfaces.
Socket Head Belt
the Belt Aasembly
REPLACING ABRASIVE BELT
Refer te Figure 24.
WARNING: Disconnect sander from power source.
• Sanding belt should be replaced when worn, torn, or
glazed. Remove belt dust chute by removing two pan head
screws
• Release belt tension by pushing tension lever toward idler
roller. Slide old belt off the ddve and idler rollers.
NOTE: There may be an arrow on the inside of the belt, The
arrow should point in the direction of belt b-avel to assure that
the splice in the belt will not come apart.
• Slide new belt over the drive and idler roller; center belt on
rollers.
• Push tension lever towards drive roller to tension belt,
• Rotate belt by hand to check traddng. Belt should dde
centered on drive and idler rollers. Adjust tracldng nut as
needed to center belt on rollers.
• Mount belt dust chute using pan head screws.
ure 24 - Replacing Belt
ABRASIVE DISC FINISHING
• Abrasive disc eand[ng Is well suited for finishing smell fiat
surfaces end convex edges
• Move workpiece across down side {right) of abrasive disc.
• Abrasive disc moves fastest and removes more material at
outer edge.
• For accuracy, uce miter gauge.
ADJUSTING DISC TABLE ANGLE
• Disc table is adiustab_e from 0 to 45 ° for beveled work,
• To adjust the disc table, loosen the two handles and pivot
to the desired angle.
• Use the scale on disc table trunnions to set table from O io
45° from abrasive disc.
• When disc table is at desired angle, lock it into position by
securely tightening the handles.
REPLACING ABRASIVE DISC
Refer to Figure 25,
WARNING: Disconnect sander from power source,
• Remove disc table end dust cover, Remove old abrasive
dlso by peeling It from the aluminum disc. Removing alu-
minute disc from motor shaft Is not necessary'.
• Clean aluminum disc if necessary. Select the proper abre-
she disc and apply to z_]uminumdisc.
DuSt Cover
Figure 25 - Replacing Abrasive Disc
10
Loading ...
Loading ...
Loading ...