Loading ...
Loading ...
Loading ...
10
Start/Stop: If you press the start/stop key, the machine starts moving after a 3 second countdown.
When press again, the machine stops moving.
Power Key: Always switch off the machine with this power key after the end of the training session.
You can also switch the machine off with the power key when it’s in motion. The machine will switch
to standby mode if there is not any training or input. Press the power key to reactivate the machine.
PROGRAMS
The machine has three programs: P1, P2 and P3. You can choose the program with program key.
Each program has a fixed moving time of 6 minutes and 40 seconds. The speed is set automatically
(see Fig. 1). Each step takes 20 seconds. The difference between the program is the type of
oscillation.
P1: Vertical oscillation
P2: Horizontal oscillation
P3: Vibration
Fig. 1
TROUBLESHOOTING
1. The machine cannot be started:
Check plug (power connection) and check if power switch is switched on.
2. Remote control does not work:
Replace battery and check if the distance between remote control and the machine is less than
max. 2 meters.
3. Other, abnormal behavior:
Disconnect the power supply, wait for 2 minutes and re-start the machine.
Error codes: E01/E05: Signal error; E02: Vertical motor error; E04: Overvoltage protection triggered;
E06: Vibration motor error; E08: Horizontal motor error.
If the problem cannot be solved with about troubleshooting, contact the customer service at
Loading ...
Loading ...
Loading ...