Loading ...
Loading ...
Loading ...
6
3. Guide fixture wire through metal
stem. Insert stem into fixture head
by aligning pin in stem with groove
in fixture head and press firmly
until you hear a click. (Fig. 8)
4. Pull fixture wiring completely
through notch in ground stake.
Push metal fixture stem into
ground stake by aligning pin in
stem with groove in ground stake.
Press firmly until you hear a click.
(Fig. 9)
5. Refer to separate instruction sheet
for repellent bottle attachment inside fixture.
6. Replace fixture head assemblies on all fixtures removed in Fig. 7.
Connect Wiring for Repellent Fixtures
1. Open main section of clip on the connector.
(Fig. 10)
2. Insert controller wire into main section of
connector. Each side of the wire needs to align
with the piercing contacts inside the main
section.
3. Squeeze two sides of connector until it clicks.
4. Locate end of fixture wires.
(Fig. 11)
5. Pull the two wires apart
approximately 3 inches.
6. Open two wire compartments
on connector.
7. Insert each fixture wire end
into opening until it stops
(approximately 1/2”) and press
closed until it clicks.
WIRE
COMPARTMENTS
FIXTURE
WIRES
Fig. 8
PIN
GROOVE
STAKE
NOTCH
Fig. 9
PIN
GROOVE
PIN
Fig. 10
Fig. 11
PIERCING
CONTACTS
Loading ...
Loading ...
Loading ...