Loading ...
Loading ...
Loading ...
5
Locate the Fixtures
1. Route the 65 feet of low voltage
wire (connected to controller)
around perimeter of desired
protection area. (Fig. 4)
2. Fixtures should be placed 12
feet or less apart surrounding
perimeter of protection area.
(Fig. 5)
3. Mark location for each fixture.
NOTE: Do not connect additional wire as this
may cause system to not function properly.
NOTE: Controller can only power up to four
fixtures.
Fixture Installation
1. Install ground stakes. Loosen hard soil and remove stones and rocks
before attempting to install ground stakes. Use provided striker cap to
protect stakes when hammering. After installation,
stake flange should be flush with grade level.
(Fig. 6)
2. Remove top of fixture by squeezing two
buttons and set aside for use later. (Fig. 7)
STRIKER
CAP
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Loading ...
Loading ...
Loading ...