Loading ...
Loading ...
Loading ...
Aboutcrisperremoval
Not all features are on all models.
Crisper Removal
To Remove:
These drawex_ can be remo',ed easil)by
lifting up slightly while pulling tile drawer
past the stop location.
When the door cannot be fully opened,
rein eve the dm wet fi_rth est from the door
first. Make sm'e the drawer closest to the
door is fifllv closed. There is a latch at the
front of the center slide rail. Push down on
the latch and slide the center slide rail, to
which the drawer is attached, a_y fl'om
the dora: Relnove the drawei:
Aboutthe automaticicemaker.
A newly-installed refrigerator may take 12-24 hours to begin making ice,
Power
Switch Icernaker
PowerLight
Powerswitch model
Feeler Armin (up)position
theON (down)
position
Feelerarm model
Automatic Icemaker (on some models)
Tile icemaker will produce seven or eight
cubes (depending on model) per cycle--
approximately 100-130 cubes in a 24-hour
period, depending on fl'eezer compartment
tellli)ei'attli'e _ i"oo1// tellli)ei'attli'e _ ntllllber
of door openings and other use conditions.
There are two t)pes of icemake_: power
switch models and feeler aml models.
If tile refl{gerator is operated before tile
water connection is made to the icemaket;
set tile power switch to 0 (Off)or move tile
teeler aml to tile STOP (up) position.
When the reflJgerator has been connected
to tile water supply, set tile power switch to
tile I (on)position or move tile feeler am/ to
tile ON (down) position. On power switch
models, the green light will come on.
You will hear a buzzing so/md each time
tile icemaker fills with water:
Tile icemaker will fill Mth water when it
cools to approximately 15°F. A newl)'-
installed refrigerator may take 12 to 24
hom_ to begin making ice cubes.
Throxx a'_av tile first tex_ batches of ice to
allow tile water line to clea_:
Be sm'e nothing intetTeres with tile sweep
of tile feeler aml.
X,_]/en tile bin fills to tile level of tile teeler
aml, tile icemaker will stop producing ice.
It is mmnal tot several cubes to be joined
together:
If ice is not used fl'equenfl> old ice cubes
will become cloud> taste stale and shrink.
On power switch models, tile green power
light will blink if ice cubes get stuck in the
icemake_: To correct this, set tile power
switch to 0 (o/i) and remove the cubes. Set
tile power switch to /(on) to restart tile
icemake_; _Mter tile icemaker has been
turned on again, there will be a delay ot
about 45 minutes betore tile icemaker
I'eStlllleS ol)eI_ltion.
NOTE:Inhomeswithlower-than-averagewater
pressure,youmayheartheicemakercyclemultiple
timeswhenmaklbgonebatchofice.
/0
Icemaker Accessory Kit
If yore" refl_igerator did not come ah'eadv
equipl)ed with an automatic icemake_;
an icemaker accessory kit is ax filable at
extra cost.
Check tile back of tile refl_igerator fin.
tile specific icemaker kit needed fin.
V()/II" II/odd.
Loading ...
Loading ...
Loading ...