Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/7428747_gpk01m1/bg10.png)
16 ENGLISH
OPERATION
CAUTION:Holdthetoolrmlywithonehandon
the switch handle and the other hand on the depth
adjustmentknobwhenoperatingthetool.
Planing operation
1. Holdthetoolrmlywithyourbothhands,one
hand on the switch handle and the other on the depth
adjustmentknob.
2. Placethefrontbaseofthetoolatuponthework-
piecesurfacewithouttheplanerbladesmakingany
contact.
3. Turn the tool on and wait until it attains full speed.
4. Gentlymovethetoolforwards,applyingslightly
moredownwardspressureonthedepthadjustment
knob at the start so as to keep the entire planer base
level and even with the workpiece surface.
Fig.33
5. Usecaretoapplypressureevenlyoverthework-
piece surface in the middle of operation, and push the
toolsteadilyforwards.
Fig.34
NOTE: Balance hand pressure between the switch
handleanddepthadjustmentknobasboththefront
and rear bases contact the workpiece surface.
6. Applygreatercontrolontheswitchhandletoavoid
overreaching at the end of a pass since the front base
willdropotheworkpiecesurface.
Fig.35
NOTE:Planingcanbeeasierifyoupositionthework-
pieceataslightforwardtiltsoyoueaseuponthe
pressure to hold the tool during operation.
NOTE:Adjustthecuttingspeedanddepthforyour
desiredsurfacenishes.
Forroughnish,setthecuttingdepthsuciently
deep enough on workpiece.
Forneatandnenish,pushthetoolslowlywith
shallow cutting depth and make more passes.
Shiplapping (Rabbeting)
Fig.36
Use the guide rule to make a stepped cut as shown in
thegure.
1. Install the guide rule and depth guide in the tool
and secure them with the washers and thumb screws.
2. Adjustthedepthguidetotheshiplappingdepth
and secure it in place with the thumb screw.
Loading ...
Loading ...
Loading ...