Loading ...
Loading ...
Loading ...
Getting through narrow spaces
If your refrigerator will not fit through an entrance
area, you can remove the doors. Check first by
measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is
unplugged from the wall outlet.
2 Open the freezer drawer and remove the toe
grille (see "Installation" section).
3 Remove any food from the door shelves and
close the doors.
To remove the top hinge covers:
1 Remove the two screws from each cover over
the top door hinges.
2 Lift inside edge of hinge cover and tilt back.
Front Rea_
_r
TopHi Screw
Hinge
Ground
Mull
.Top
Hinge
Leave
Hing_
Water
Door Line
Front
Rear Cover Screw
Screw
,,Top Hinge
Cover
Top Ground
Hinge
Screws
ire
Cables
Leave
Hinge
With
Door
To remove the refrigerator doors:
1 Trace lightly around the door's top hinges
with a pencil. This makes reinstallation easier.
Disconnect the harness by grasping both
sides of the connector firmly, depress the
latch, and pull apart. Remove the two screws
from the top hinge. Lift the door off of the
bottom hinge and set it aside.
Detach the water tube from the connector
located behind the refrigerator and pull the
tube back out to the front of the unit. The
connector releases when you press inward
on the outer sleeve while pushing the tube
toward the connector then while continuing to
hold in the sleeve, pull the tube away.
Use care while pullingthe water tube from the
unit to be sure that you do not kink the tube.
DO NOT remove the ground screw from hinge.
Loading ...
Loading ...
Loading ...