Ancona AN1248 User Manual

Loading ...

— 16 —

STEP 11

Venting

 Depending on exterior ventilation chosen (see page 10), either exit the ducting through the ceiling or wall.

 



seal with certied aluminum or foil tape so that it is air tight. Please check the building codes in your city to learn which

tape product is recommended.

 Connect ductwork to damper. Use Duct Tape to ensure joint is sealed and air tight.

IMPORTANT:

 

 It is the customer’s responsibility to contact a qualified electrical installer.

 



circuit, fused on both sides of the line.

 

 

 

IMPORTANT: Save this Installation Guide for electrical inspector’s use.

GROUNDING INSTRUCTIONS:

 

shock by providing an escape wire for the electric current.

WARNING: Improper grounding can result in a risk of electric shock.

 

whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,

have a qualified electrician install an outlet near the appliance.

 

the fused disconnect (or circuit breaker) box through flexible armored or non-metallic sheathed copper cable. UL/

CSA listed strain relief must be provided at each end of the power supply cable. Use only with range hood cord-

connection kits that have been investigated and found acceptable for use with this model.

Installation

Loading ...

Ancona AN1248 30 Inch Stainless Steel Ducted Standard Hood Under Cabinet Hood