Loading ...
Loading ...
Loading ...
27INSTALLATION
ENGLISH
4 Insert a small, flat-blade screwdriver with a
minimum length of 3" (76.2 mm) and a
diameter of 3/32" (2.4 mm) into the opening
marked below.
a Simmer on dual burner
b Simmer on other burners
5 Turn the screw to adjust.
• Hold the valve shaft with one hand while
turning the screw to adjust with the other.
6 Replace the knob.
7 Test the flame stability.
• Test 1: Turn the knob from Hi to Lo quickly.
If the flame goes out, increase the flame
size and test again.
• Test 2: With the burner on a Lo setting,
open and close the oven door quickly. If the
flame is extinguished by the air currents
created by the door movement, increase
the flame height and test again.
8 Repeat steps 1-7 for each surface burner.
NOTE
• The product is shipped with the low flame
(Simmer) setting at the lower limit. It cannot be
set any lower.
Optional Rear Filler
Installing the Rear Filler
If the counter does not bridge the opening at the
rear wall, the rear filler kit which is provided with
the slide in range will be needed.
NOTE
• If the countertop depth is greater than 25 3/8 "
there will be a gap between the filler kit and the
back wall.
• If the countertop depth is less than 24 3/4 ", the
control panel will not sit flush with the
countertop.
1 Using a screwdriver, remove the three screws
holding the rear bracket in place.
a Rear bracket
2 Attach the rear bracket and filler assembly as
shown, using the three screws removed in
step 1.
b Rear filler
Anti-tip Device
Installing the Anti-tip Device
Tip Hazard
WARNING
• A child or adult can tip the range and be killed.
Loading ...
Loading ...
Loading ...