Loading ...
Loading ...
Loading ...
AM antenna
ConnectingSpeakers
E:>
I
inyl-covered wire
FM7s_ AM } (not supplied)
AM loop antenna
(supplied)
1 Press and hold the clamp of the AM terminal
on the rear of the unit.
2 Insert the end of the AM loop antenna cord
into the terminal. A_ J
• If the AM loop antenna wire is covered /!_
with vinyl, remove the vinyl by twisting it
as shown in the diagram.
3 Release the finger from the clamp.
4 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM terminal and extend it horizontally. (The AM loop
antenna must remain connected.)
_For better reception of both FM and AM
* Make sure the antenna conductors do not touch any other
terminals and connecting cords.
° Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
For MX-GT700:
DO NOT carry the speaker by holding the duct
tube (on the top of the speaker).
f
1
2,3
E:>
_. , .j
Speaker cord Black // Speaker
(blue/black) A / / / cord
( MAIN SPEAKF_I'_SUBWOOFERI 1/ / (red/black)
"-_ E4_1/ \ Ee-l_l It' /
Blue Red
Black
\
Speaker cord Speaker cord
(blue/black) (red/black)
From right From right
main subwoofer's
speaker's terminals
terminals
From left From left
main subwoofer's
speaker's terminals
terminals
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity (colors): Blue (+) to blue (+) and black
(-) to black (-); red (+) to red (+) and black (-) to black
(-).
• If the wire is covered with vinyl, remove
the vinyl by twisting it as shown in the
diagram.
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
7
Loading ...
Loading ...
Loading ...