Loading ...
Loading ...
Loading ...
OPERATION
iMPORTANTSAFETYiNSTRUCTiONS
To reducethe riskof SEVEREiNJURYor DEATH:
1. READAND FOLLOWALL WARNINGSAND iNSTRUCTiONS.
2. ALWAYS keep remotecontrols out of reach of children. NEVER
permit children to operate or play with garage door control
push buttons or remote controls.
3. ONLYactivategarage door when it can be seen deafly, it
is properly adjusted, and there areno obstructions to door
travel.
4. ALWAYS keepgaragedoor in sight until completely closed.
NOONESHOULDCROSSTHE PATHOFTHE MOVINGDOOR.
5. NOONESHOULDGO UNDERA STOPPED,PARTIALLY
OPENEDDOOR.
6. if possible, use emergency releasehandleto disengagetrolley
ONLYwhen garagedoor is CLOSED.Weak or broken springs
or unbalanced door could result in an open door falling rapidly
and/or unexpectedly,causing SEVEREINJURYor DEATH.
7. NEVERuse emergency releasehandle unless garagedoorway
is clear of persons and obstructions.
8. NEVERuse handleto pull garage door open or closed, if rope
knot becomes untied, you could fall.
9. if one control (force or travel limits) is adjusted, the other
control may also need adjustment.
10. After ANY adjustments are made,the safety reversal system
MUST be tested.
11. Safety reversal system MUST be tested every month. Garage
door MUST reverseon contact with 1-1/2" high (3.8 cm)
object (or a 2x4 laidflat) on the floor. Failureto adjust the
garagedoor opener properly may cause SEVEREINJURY or
DEATH.
12. ALWAYSKEEPGARAGEDOORPROPERLYBALANCED
(see page3). An improperly balanced door may NOTreverse
when required and could result in SEVEREINJURY or
DEATH.
13. ALL repairs to cables, spring assemblies and other
hardware,ALL of which are under EXTREMEtension, MUST
be made by a trained door systems technician.
14. ALWAYSdisconnect electric power to garage door opener
BEFOREmaking ANY repairs or removing covers.
15SAVETHESEINSTRUCTIONS.
Using Your Garage Door Opener
Your Security÷ <_'opener and hand-held remote control
have been factory-set to a matching code which changes
with each use, randomly accessing over 100 billion new
codes. Your opener will operate with up to eight
Security÷ <_'remote controls and one Security÷ <_'Keyless
Entry System. if you purchase a new remote, or if you
wish to deactivate any remote, follow the instructions in
the Programming section.
Activate your opener with any of the following:
• The hand-held Remote Control: Hold the large push
button down until the door starts to move.
• The wall-mounted Door Control: Hold the push button
or bar down until the door starts to move.
• The Keyless Entry (See Accessories): if provided with
your garage door opener, it must be programmed
before use. See Programming,
When the opener is activated (with the safety
reversing sensor correctly installed and aligned)
1. if open, the door will close, if closed, it will open.
2. if closing, the door will reverse.
3. if opening, the door will stop.
4. if the door has been stopped in a partially open
position, it will close.
5. if obstructed while closing, the door will reverse, if the
obstruction interrupts the sensor beam, the opener
lights will blink for five seconds.
3O
6. if obstructed while opening, the door will stop.
7. if fully open, the door will not close when the beam is
broken. The sensor has no effect in the opening cycle.
if the sensor is not installed, or is misaligned, the door
won't close from a hand-held remote. However, you can
close the door with the Door Control, the Outdoor Key
Switch, or Keyless Entry, if you activate them until down
travel is complete, if you release them too soon, the door
will reverse.
The opener lights will turn on under the following
conditions: when the opener is initially plugged in; when
power is restored after interruption; when the opener is
activated. They will turn off automatically after 4-1/2
minutes. Bulb size is A19. Power is 100 watts maximum.
Lights will also turn on when someone walks through the
open garage door.
Loading ...
Loading ...
Loading ...