Loading ...
Loading ...
Loading ...
ASSEMBLY ST P 4
Install the Chain/Cable
1. Pull the cable around the idler pulley and toward the
trolley.
2. Connect the cable to the retaining slot on the trolley, as
shown (Figure 1):
• From below, push pins of master link bar up through
cable link and trolley slot.
• Push master link cap over pins and past pin notches.
• Slide clip-on spring over cap and onto pin notches
until both pins are securely locked in place.
3. With the trolley against the screwdriver, dispense the
remainder of the cable/chain along the rail toward the
motor unit into the slot on the chain spreader, around
the sprocket onto the chain spreader and continuing to
the trolley assembly. The sprocket teeth must engage
the chain (Figure 2).
4. Check to make sure the chain is not twisted, then
connect it to the threaded shaft with the remaining
master link.
5. Thread the inner nut and lock washer onto the trolley
threaded shaft (Figure 3).
6. Insert the trolley threaded shaft through the hole in the
trolley. Be sure the chain is not twisted (Figure 3).
7. Loosely thread the outer nut onto the trolley
threaded shaft.
8. Remove the screwdriver.
Figure 1
To avoid possible SERIOUSINJURYto fingers from moving
garagedoor opener:
• ALWAYS keep hand clear of sprocket while operating
opener.
• Securely attach chain spreader BEFOREoperating.
Dispensing Carton
LeaveChain and Cable
Inside Dispensing
Carton to Prevent Kinking.
Figure 2
Keep Chain and Cable
Taut When Dispensing
Sprocket
Figure 3
Outer Nut
Master
Inner Nut
Lock Washer,
Front Rail
Section
(TO DOOR)
Threaded
Shaft
Master Link
10
Loading ...
Loading ...
Loading ...