Loading ...
Loading ...
Loading ...
6
INSTALLATION INSTRUCTIONS
Before Using your Appliance
•
Remove the exterior and interior packing.
•
Before connecting the appliance to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
•
Clean the interior surface with lukewarm water, using a soft cloth.
•
Install the handle on the drawers if they are not already attached.
Installation of your Appliance
The appliance is designed for built-in, recessed, or free-standing installation
CAUTION: This appliance is not designed for the storage of medicine or other medical products.
•
Place your appliance where the floor is strong enough to support it when it is fully loaded. To
level the appliance, adjust the front leveling legs.
•
For free-standing installation, 5” (127mm) of space between the back and sides of the
appliance, and 4” (102mm) at the top, are suggested. This allows for proper air circulation.
For built-in installation, keep 2” (50mm) at the rear. Make sure the air ventilation channels at
the back of appliances are never covered or blocked in any way.
•
Avoid locating the appliance in moist areas.
•
Plug the appliance into an exclusive, properly grounded wall outlet.
NOTE: It is recommended that you do not install the appliance near an oven, radiator, or other
heating sources. Heat sources may increase electrical consumption, and direct sunlight may
affect the outer coating. Do not install in a location where the temperature will fall below
50°F (10°C). For best performance, do not install the appliance behind a cabinet door or
block the base grille.
Built-in Installation
CAUTION: For this model, please take into consideration the clearances required for air intake and
exhaust.
Hot air must be driven by the ventilation to the rear wall of the cooler and then expelled upwards.
The ventilation channels shall be at least 5.11”x2.36” (130x60mm) in cross-section.
Warning: to ensure proper operation, the ventilation grilles must never be obstructed or covered.
Loading ...
Loading ...
Loading ...