Loading ...
Loading ...
Loading ...
12
8.4” (214mm)
Installing the Stainless Steel Handle
This appliance includes one stainless steel handle
that is not required to operate the appliance. To
install the handle, follow the instructions below:
1. Remove the door gasket.
2. Install the handle with the screws provided. DO
NOT over-tighten as this will cause damage to
the stainless steel door surface.
3. Reinstall the door gasket.
Full Overlay Panel Installation
Instructions
This model is designed for a field-installed
overlay panel, which can cover the stainless
steel to give a built-in appearance. The
overlay panel and appropriate hardware are
not included with the appliance, and you must
install the panel yourself.
Please follow the instructions below for
installation:
1.
Remove any items stored inside the
drawers and take the drawers out.
2.
Peel off the gasket and remove the handle
by
removing the two screws that attach the
handle to the door.
3.
Drill the 6 holes shown by using a 9/50”
drill bit on
the 4 sides of the drawer door
front. (Fig.2)
4.
Cut the overlay panels with 3/4” thickness
to the
following dimensions: 17.87” x
11.9” (WxH).
5.
If reusing the handle that came with the
appliance, drill two holes with a diameter
of 9/50” in the overlay panel.
6.
If user-supplied handle will be used,
attach the handle to the overlay panels by
using the flat head screws and drive the
screws flush with the panels.
7.
Attach the handle and overlay panel
together to the drawer face using 2
M4x45 screws and through the 2 existing
holes on the door face. Then attach the
overlay panel to the drawer face using 6
M4x45 screws and through 6 existing
holes inside the door groove. (Fig. 3)
8.
Attach the overlay panel to the drawer face
through
the existing holes inside the door
groove, using the 6 M4x45 screws.
9.
Peel back the gaskets, then align the left
and right side channels with the tracks in the
cabinet.
6.14” (156mm)
Loading ...
Loading ...
Loading ...