Loading ...
Loading ...
Loading ...
installation & maintenance_19
CAUTION
ADDING DETERGENT
1. Open the detergent drawer and then add the powder detergent into the detergent
compartment.
2. Add detergent evenly so that it doesn’t brim over the edge of the drawer.
• Use a reasonable amount of detergent.
If you use more detergent than the standard quantity or the water temperature is too
low and the detergent does not dissolve in the water completely causing it to remain
on the laundry and in the hose and tub, it may cause damage such as dirtying and
discoloring the laundry.
• If you use a powder detergent and it remains on the laundry, it may cause a bad odor.
Rinse the laundry suffi ciently in fresh water.
If you spread a powder detergent over the laundry directly, it may result in discoloration.
Make sure to insert it into the detergent compartment.
If the water pressure is low, the detergent may remain in the detergent compartment.
Using the liquid detergent
• To use the liquid detergent, place the liquid detergent container into the detergent
compartment and add the liquid detergent into the liquid detergent container.
• Do not add the powder detergent into the liquid detergent container. Remove the liquid
detergent container before using the powder detergent.
ADDING FABRIC SOFTENER
1. When the proper amount (one time dose) of fabric softener is stored in the softener inlet, it is
automatically added during the last rinse cycle.
2. Do not add detergent, bleach or starch into the softener inlet.
3. Using too much softener may produce unsatisfactory results.
4. Do not open the lid during the Spin cycle. If added too early, its effectiveness will decrease.
5. Do not leave the softener in the softener dispenser for a long time as it may congeal.
If the water pressure is low, the fabric softener may remain in the softener compartment. In
this case, put the fabric softener into the tub directly.
WATER SUPPLY CONNECTOR FILTER
1. Pull out the fi lter and wash well.
Periodically perform operation.
2. Pull in the fi lter and connect the hose to the inlet
water valve tightly.
3. Check if there is a leakage.
Note to tighten up the connector.
CAUTION
03 INSTALLATION & MAINTENANCE
F700S_DC68-03271Q-01_EN.indd Sec6:19F700S_DC68-03271Q-01_EN.indd Sec6:19 7/27/2020 11:33:41 AM7/27/2020 11:33:41 AM
Loading ...
Loading ...
Loading ...