Loading ...
Loading ...
Loading ...
Timing the First and Second
Place Finishers
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
E
A
E
2nd Finisher*
1st Finisher*
Start
* Displays the time of the first finisher.
●
Elapsed time is shown in 1/1000-
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
Hours, minutes, seconds,
1/10 seconds
After first hour
Minutes, seconds,
1/1000 seconds
First hour
3. Press (A) to display the time of the second
finisher.
4. Press (A) to reset the elapsed time to all
zeros.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted when battery power is
low.
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the hour digits
start to flash.
Hours
3. Use (B) and (E) to change the timer hours
setting.
●
To countdown 24 hours, set [0:00'00.0]
for the start time.
4. Press (D).
This causes the minutes digits to flash.
Minutes
5. Use (B) and (E) to change the timer
minutes setting.
6. Press (D).
This causes the seconds digits to flash.
Seconds
7. Use (B) and (E) to change the timer
seconds setting.
8. Press (A) to exit the setting screen.
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Use the operations below to perform a
timer operation.
E
E
E
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
To reset a paused countdown to the
start time, press (A).
3. Press any button to stop the tone.
Operation Guide 5608
12
Loading ...
Loading ...
Loading ...