Loading ...
Loading ...
Loading ...
8
8.0 Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Slip Roll
is assembled and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of container:
1 Electric Slip Roll
1 Foot pedal control assembly
2 Keys to electrical box
1 Instruction and parts manual
1 Warranty card
Remove all crating from around the slip roller,
and use a forklift or hoist with straps to carefully
move the machine off the pallet and into
position. Lifting equipment should be rated for at
least 900 pounds.
Position the machine so that there is enough
room on all sides for general maintenance and
feeding of materials. Anchor the slip roller to the
floor using lag screws or other appropriate
fasteners through the four holes in the base.
Exposed metal surfaces have been given a
protective coating. Remove this with a soft cloth
and a cleaner-degreaser. Do not use gasoline,
paint thinner, acetone, etc., as these may
damage painted surfaces. Do not use an
abrasive pad, as it may scratch polished
surfaces.
9.0 Electrical Connection
Electrical power connections
should be made by a qualified electrician.
Observe national and local electrical codes
when connecting this machine.
Single phase model: The ESR-1650T-1 is pre-
wired for 230 volt. It can be converted to 115
volt, as follows:
1. Disconnect machine from power source.
2. Open the control box, and pull down (shut
off) the 230V breaker switch. Switch on the
115V breaker. See Figure 3.
3. On the front of the machine, turn the rotary
dial to 115V (Figure 4).
4. Make sure a proper UL-listed plug is
installed.
It is recommended that the ESR-1650T-1, when
operated at 115V, be connected to a dedicated
20 amp circuit with a 20 amp circuit breaker or
time delay fuse. When operated at 230V,
connect to a dedicated 15 amp circuit with a 15
amp circuit breaker or time delay fuse. Local
codes take precedence over recommen-
dations.
Figure 3
Figure 4
Three phase model: The ESR-1650T-3 is pre-
wired for 230 volt. It is not provided with a power
plug; you may either attach a proper 230V UL-
listed plug, or “hardwire” the machine directly to
a service panel (make sure a disconnect is
available to the operator).
The three-phase model can be converted to 460
volt, as follows:
1. Connect the motor leads according to the
diagram affixed to the motor.
2. On the transformer, remove the wire
terminal from the 230V contact and connect
to the 460V contact.
3. On the thermal relay, make sure the dial is
set to the proper amperage.
4. If using a plug, install a proper 460V, UL-
listed plug.
Loading ...
Loading ...
Loading ...