Loading ...
Loading ...
Loading ...
Wall Mounting & Position Instructions cont.
1. Mark the positions of the four holes to be
drilled on the wall. Ensure there is a 300mm
clearance on all sides of the heater.
2. Drill holes with an appropriate drill bit for the
wall surface you are mounting the heater on
to.
3. Insert the plastic rail fittings into the holes.
4. Install the panel heater onto the four rail fittings
matching the four holes on the heater.
5. Screw the four screw bolts into the plastic rail
fittings.
6. Put the caps onto the end of the screw bolts. It is
recommended to use some normal glue to stick
the caps onto the bolts steadily.
To remove the unit from the wall, simply remove the bolt caps, unscrew the bolts with a screw driver and take
the heater down.
NOTE: Your Goldair EcoPanel Heater should be installed with at least 300mm clearance from the floor
and any other surrounding parts including other appliances, side walls, ceilings, shelves and soft
furnishings.
Orientation.
The heater must be mounted on the wall with the power switch in the top right hand
position as shown below.
Note: Do not run power
cord behind the heater.
THIS
WAY UP
Loading ...
Loading ...
Loading ...