Loading ...
Loading ...
Loading ...
English
9
Fig. D
3
2
13
Bit and Bit Holder
WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage barehands.
The rotary hammer can be fitted with various chisel bits
depending on the desired application. Use sharp drill
bitsonly.
Inserting and Removing SDS MAX Bits
(Fig. E)
1. Insert bit in the bit holder
6
and apply downward
pressure while rotating to secure the bit into place. The
bit shank must beclean.
2. Ensure the bit is properlyengaged.
nOTE: The bit needs to move several centimeters in and
out of the bit holder
6
when properlyengaged.
6
7
Fig. E
3. To remove the bit, pull back the locking sleeve
7
and
pull the bitout.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Installing and Removing the Battery Pack
(Fig. F)
nOTE: For best results, make sure your battery pack is
fullycharged.
To install the battery pack
8
into the tool’s battery cage,
align the battery pack with the rails inside the tool’s battery
cage and slide it in until the battery pack is firmly seated.
Ensure that it does notdisengage.
To remove the battery pack from the tool, press the release
button
9
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of thismanual.
Fig. F
8
9
Proper Hand Position (Fig. G)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
suddenreaction.
Proper hand position requires one hand on the mounted
side handle
2
, with the other hand on the mainhandle
5
.
Fig. G
5
2
SHOCKS Active Vibration Control®
System
For best vibration control, hold the tool as described in
Proper Hand Position and apply just enough pressure so
the damping device on the main handle is approximately
mid stroke. The hammer only needs enough pressure to
engage the active vibration control. Applying too much
pressure will not make the tool actuate faster and active
vibration control will notengage.
DEWALT
Tool Tag Ready (Fig. A)
Optional Accessory
Your hammer comes with mounting holes
12
and
fasteners for installing a
DEWALT
Tool Tag. You will need a
T15 bit tip to install the tag. Only use the screws provided.
The
DEWALT
Tool Tag is designed for tracking and locating
professional power tools, equipment, and machines using
the
DEWALT
Tool Connect™ app. For proper installation
and use of the
DEWALT
Tool Tag refer to the
DEWALT
Tool
Tagmanual.
Loading ...
Loading ...
Loading ...