Loading ...
Loading ...
Loading ...
31-5000473 Rev. 0 15
ENGLISH
INSTALLATION INSTRUCTIONS
Installing the architectural frame on the body of indoor unit:
• Orient the panel so the wire harness can properly reach the control box
prior to attaching the panel.
• Temporarily hang the panel with the hook screws.
• Start to thread the corner screws until each screw has started. Position the hook screws facing inside, and finish
tightening the corner screws.
• Lower the body of the indoor unit if the foam gasket does not seal with the frame.
• Wiring of panel: Connect both connections for the display and louver motors.
WARNING
Leaking air could cause moisture to condense on the ceiling surface and
cause water damage if the panel does not seal against the unit.
The unit must be installed level for water to drain from the condensate pan.
Water damage
Air leakage
Condensing
moisture
Any gap is not allowed
Side of decorated board
Side of indoor unit
(may vary)
Loading ...
Loading ...
Loading ...