Loading ...
Loading ...
Loading ...
-16-
Please refer to figures 14 - 16 for further instruction on how to use your Dremel Multi-Max™.
Following these instructions will allow you to get the highest performance out of your
oscillating tool.
Variable Speed Control Dial
This tool is equipped with a variable speed
control dial (Fig. 13). The speed may be
controlled during operation by presetting the
dial in any one of ten positions.
Operating Speeds
The Dremel Multi-Max™ consists of an DC
motor and oscillating mechanism to perform
applications such as cutting, grout removal,
scraping, sanding and more.
The Dremel Multi-Max™ MM20V has a high
oscillating motion of 10,000 - 20,000 /min
(OPM). The high speed motion allows the
Dremel Multi-Max™ to achieve excellent
results. The oscillating motion allows the dust
to fall to the surface rather than discharging
particles into the air.
To achieve the best results when working
with different materials, set the variable
speed control to suit the job (See Speed
Chart on page 18 & 19 for guidance). To
select the right speed for the accessory in
use, practice with scrap material first.
The variable speed control settings are
marked on the speed control dial.
You can refer to the charts on the following
pages to determine the proper speed dial
setting, based on the material and accessory
being used. These charts enable you to select
both the correct accessory and the optimum
speed dial setting at a glance.
4
FIG. 13
Variable Speed
Control Dial
Operating Instructions
FIG. 14
CORRECT: Always sand with the pad and
sandpaper flat against the work surface.
Work smoothly in a back and forth
motion, allowing the weight of the tool to
do the work.
INCORRECT: Avoid tipping the pad.
Always sand flat, keeping as much sand
paper in contact with the work surface as
possible.
SANDING TECHNIQUES
1605A000KS MM20V 05-21.qxp_MM20V 5/18/21 7:02 AM Page 16
Loading ...
Loading ...
Loading ...