Loading ...
Loading ...
Loading ...
-13-
Installing and Removing
Sanding Sheets
Your backing pad uses hook-and-loop
backed sandpaper, which firmly grips the
backing pad when applied with moderate
pressure.
1. Align the sanding sheet and press it
onto the sanding plate by hand.
2. Firmly press the power tool with the
sanding sheet against a flat surface and
briefly switch the power tool on. This
will promote good adhesion and helps
to prevent premature wear.
3. To change, merely peel off the old
sanding sheet, remove dust from the
backing pad, if necessary, and press
the new sanding sheet in place.
After considerable service the backing pad
surface will become worn, and the backing
pad must be replaced when it no longer
offers a firm grip. If you are experiencing
premature wear-out of the backing pad
face, decrease the amount of pressure you
are applying during operation of the tool.
For maximum use of abrasive, rotate pad
120 degrees when tip of abrasive becomes
worn.
Assembly
1605A000KS MM20V 05-21.qxp_MM20V 5/18/21 7:01 AM Page 13
Loading ...
Loading ...
Loading ...