Loading ...
Loading ...
Loading ...
NOTE:Installationhardwareisnotprovidedwithfullcabinet
models.See"Accessories"fororderingconversionkit.
• Ifthecompactorcabinetfaceistobeflushwiththe
kitchencabinetface,placeretainingbracketmounting
screwsthrough"1."
• Ifthecompactordrawerfrontistobeflushwiththe
kitchencabinetface,placeretainingbracketmounting
screwsthrough"3."
• Ifthecompactoristobemidwaybetween"1"and"3,"
placetheretainingbracketmountingscrewsthrough"2."
IB
A. Countertop
B.Retainingbracket (provided in conversion kit)
9. Slowly lift the front slightly and roll compactor into the kitchen
cabinet opening.
10. Using 2 - #8 - 18 x 1/2"mounting screws (provided in
conversion kit), fasten the retaining brackets (provided in
conversion kit) to the countertop with the mounting screws.
Countertop Mounting
A. Countertop
B. Retaining bracket (provided in conversion kit)
C. Mounting screw (provided in conversion kit)
NOTE: If retaining brackets cannot be attached to the underside
of countertop, attach mounting clips (provided in conversion kit)
to retaining brackets. Fasten compactor to kitchen cabinet face
with mounting screws through the mounting clips.
Cabinet-face Mounting
D
A. Mounting clip (provided
in conversion kit)
B. Kitchen cabinet
C. Retaining bracket (provided in
conversion kit)
D. Mounting screw (provided in
conversion kit)
11. Grasp sides of compactor drawer and place bottom of
drawer into tracks.
12. Lift at the handle so drawer will go over drawer stops.
13. Close drawer.
14. Check to see whether drawer opens freely. If the toe plate
rubs against floor, see "Adjusting the Toe Plate" for further
instructions.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance
may be changed as follows:
1. Mark on each side of the toe plate the amount of toe plate
that rubs the floor covering.
2. Remove the drawer from the unit. See Step 3 in the
"Unpacking" section.
3. Use a ruler and a pencil or chalk to draw a line between the
marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering, repeat
steps 1 to 4.
6
Loading ...
Loading ...
Loading ...