Loading ...
Loading ...
Loading ...
15INSTALLATION
ENGLISH
Unpacking and Removing
Shipping Material
Unpacking Shipping Material
* This feature is only available on some models.
Lifting the Appliance off the Foam
Base
• After removing the carton and shipping
material, lift the appliance off the foam base.
• Make sure the plastic drum support
a* comes
off with the base and is not stuck to the bottom
of the appliance.
• If you must lay the appliance down to remove
the carton base b, always protect the side of the
appliance and lay it carefully on its side. Do not
lay the appliance on its front or back.
CAUTION
• Remove all shipping materials from the
appliance for proper operation and inspect it for
shipping damage. Failure to remove shipping
materials can cause excessive noise and
vibration.
Removing Shipping Material
1 Remove the bolt assemblies.
• Starting with the bottom two shipping bolts,
use the included wrench c to fully loosen
all 4 shipping bolts by turning them
counterclockwise.
• Remove the bolt assemblies (bolts and
retainers) by wiggling them slightly while
pulling them out.
• The power cord is secured to the back of the
washer with a shipping bolt to help prevent
operation with shipping bolts in place.
2 Install the hole caps.
• Locate the hole caps d included in the
accessory pack or attached to the back of
the washer. Install the caps in the holes left
by the bolt assemblies.
CAUTION
• Once removed, save the bolt assemblies for
future use. To prevent damage to internal
components, do not transport the appliance
without reinstalling the shipping bolts. Failure to
remove shipping bolts and retainers may cause
severe vibration and noise, which can lead to
permanent damage to the appliance.
Connecting Electric Dryers
WARNING
• To reduce the risk of fire or explosion, electric
shock, property damage, injury to persons, or
death when using this appliance, fulfill the
following requirements.
Electrical Requirements for Electric
Models Only
*
Loading ...
Loading ...
Loading ...