Loading ...
Loading ...
Loading ...
Troubleshooting en
49
Fault Cause and troubleshooting
The programme dura-
tion changes during
the wash cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
▶ Not a fault – no action required.
Drum jerks after the
programme starts.
This is caused by an internal motor test.
▶ Not a fault – no action required.
Rushing, hissing
noise.
Water is flushed under pressure into the detergent
drawer.
▶ Not a fault – normal operating noise.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Too much detergent/fabric softener in the detergent
drawer.
▶ When dosing liquid detergent and fabric softener,
observe the marking in the detergent drawer and
do not dose above this.
Start/ Reload can-
not be operated.
Drying phase active.
▶ Not a fault – no action required.
Loading ...
Loading ...
Loading ...