ONE-ZONE MECHANICAL WATER TIMER
25118EDAMZ
WARNING: This product can expose you to chemicals including styrene,
which is known to the State of California to cause cancer. For more
information go to www.P65Warnings.ca.gov.
Made in Taiwan www.edengarden.com
Step 01:
Secure the timer to an outside faucet (Do not overtighten)
CAUTION
Intended for outdoor use only. Severe electrical shock could result if water is sprayed into outlets or sources of electrical current.
Do not use water more than 115°F (46°C). Do not use when the ambient air temperature is less 40°F (4.5°C). When not in use,
drain and store indoors away from freezing temperatures.
Step 02:
Attach the hose to the timer
Step 03:
Connect the watering tool to the hose end
Step 04:
Turn on the water
Step 05:
Set the desired watering time by rotating the knob clockwise.
Watering will begin and stop automatically after the allotted time
Installation:
¾” Faucet connection
Wire mesh lter prevents clogs
Water output (male thread)
For un-timed water ow, simply turn the knob counterclockwise to “Manual On”.
To turn the water ow o, move the knob back to 0.
Manual operation:
Freezing temperatures can cause water in the timer to freeze and expand, damaging the timer.
At the end of the season or when there is frost in the forecast, turn o the water and remove your timer from the faucet.
Be sure to store the timer indoors, away from freezing temperatures.
Seasonal storage:
You should clean your timer periodically. Debris or sediments commonly found in water can build up in your timer.
Turn o the water. Remove the timer from the faucet and check that the lter washer is clear. If you notice any debris, remove
the lter washer and clean it out with water.
Activate the MANUAL mode by rotating the knob to “MANUAL ON”. Spray water through the valve and the faucet connection to
ush out any built-up sediments or debris.
Cleaning Your Timer:
Waters up to two hours
No batteries required
Ergonomic swivel control knob
Switch to manual operation at anytime
