Loading ...
Loading ...
Loading ...
6
advisable to keep only the cylinder being
used in the room, positioned so that it is
not subject to heat produced by external
sources (ovens, replaces, stoves, etc� )
which could raise the temperature of the
cylinder above 50°C�
Carry out all cabinet cutting works
before tting the appliance in the
furniture and remove all wood chips and
sawdust�
If the appliance is Not installed above
an oven, a separator panel (not included)
must be installed in the compartment
under the appliance�
Should you experience diculty in turning the burners
knobs, please contact After Sales Service for replacement
of the burner tap if found to be faulty�
The openings used for the ventilation and dispersion of
heat must never be covered�
GAS CONNECTION
WARNING : Prior to installation, ensure
that the local distribution conditions
(nature of gas and gas pressure) and the
adjustment of the appliance are
compatible�
Check that the pressure of the gas
supply is consistent with the values
indicated in Table 1 (“Burner and nozzle
specications”)�
WARNING : The adjustment conditions
for this appliance are stated on the label (or
data plate)�
WARNING : This appliance is not
connected to a combustion products
evacuation device� It shall be installed and
connected in accordance with current
installation regulations� Particular attention
shall be given to the relevant requirements
regarding ventilation�
If the appliances is connected to liquid
gas, the regulation screw must be fastened
as tightly as possible�
IMPORTANT : When gas cylinder is
adopted, the gas cylinder or gas container
must be properly settled (vertical
orientation)�
WARNING : This operation must be
performed by a qualied technician
Use only exible or rigid metal hose for gas
connection�
Connection with a rigid pipe (copper or
steel) Connection to the gas system must
be carried out in such a way as not to place
any strain of any kind on the appliance�
There is an adjustable L-shaped pipe tting
on the appliance supply ramp and this is
tted with a seal in order to prevent leaks�
The seal must always be replaced after
rotating the pipe tting (the seal is
provided with the appliance)� The gas
supply pipe tting is a threaded 1/2 gas
cylindrical male attachment�
Connecting a exible joint less stainless
steel pipe to a threaded attachment The
gas supply pipe tting is a threaded 1/2 gas
cylindrical male attachment� These pipes
must be installed so that they are never
longer than 2000 mm when fully extended�
Once connection has been carried out,
make sure that the exible metal pipe does
not touch any moving parts and is not
compressed� Only use pipes and seals that
comply with current National regulations�
IMPORTANT : If a stainless steel hose is
used, it must be installed so as not touch
any mobile part of the furniture (e�g�
drawer)� It must pass through an area
where there are no obstructions and where
it is possible to inspect it on all its length�
The appliance should be connected to
the main gas supply or to gas cylinder in
compliance with the current National
regulations� Before carry out the
connection, make sure that the appliance is
compatible with the gas supply you wish to
use� If this is not the case, follow the
instructions indicated in the paragraph
“Adapting to dierent types of gas”�
After connection to the gas supply,
check for leaks with soapy water� Light up
the burners and turn the knobs from max
position 1* to minimum position 2* to
check ame stability�
Loading ...
Loading ...
Loading ...