Loading ...
Loading ...
Loading ...
Controller - Operator Settings
20
With the Oven in ‘Stand-By’ Mode (i.e. Power to oven but both displays are blank).
1. ENTERING THE OPERATOR SETTING MODE.
Press and hold 'Steam' and ‘Timer-Start/Stop’ keys together for 3 seconds.
Upper Display will show .
Lower Display will flash .
2. SETTING PASSWORD (OPERATOR PASSWORD - 123).
Rotate ‘Timer’ knob to set password .
Press ‘Fan Lo’ key to confirm password.
Upper Display will show one of the setting codes, eg.
Lower Display will show the value of the setting, eg.
3. CHANGING THE OPERATOR SETTINGS.
Rotate ‘Timer’ knob to the setting required.
Press ‘Fan Lo’ key to confirm setting required. Lower Display will flash.
While Lower Display is flashing, rotate ‘Timer’ knob to select value required.
Press ‘Fan Lo’ key to confirm value. Lower Display will stop flashing.
4. EXITING THE OPERATOR SETTING MODE.
Press ‘On-Off/Light’ key, to return to Stand-By Mode.
Oven Pre-Heat; - (Automatic Pre-Heat Temp on oven start-up).
60 - 260°C
140 - 500°F.
150ºC
(302ºF)
Alarm Volume - Can be adjusted to suit operators preference.
0 - 10. 5
Program Pre-Heating Condition - This setting allow s for pre-heating ‘Ready’ temperature in
‘Program Mode’ Mode to be set higher than Program Set Temperature. Factory Default setting is
‘0’ (Equal to Program Setting).
0 - 30°C
0 - 54°F.
0
Light Auto ‘Off’ Setting Time - (E32 from Ser. No. 759469).
0 = ‘On/Off’.
1 = 1 minute auto ‘Off’.
2 = 2 minutes auto ‘Off’, etc.
0 - 60 mins. 0
Multi-Stage Enable - (E32 from Ser. No. 759469).
This setting enables multi-stage programming. Factory default is ‘YES’, multi-stage programming is
enabled. Setting this to ‘no’ simplifies programming and program cooking.
‘YES’ or ‘no’. YES
Enable Steam Injection.
0 = No Steam.
1 = Bake Steam.
2 = Moisture Mode.
2 Yes
Loading ...
Loading ...
Loading ...