Loading ...
Loading ...
Loading ...
11
3. When the OK light comes on, turn the mode selector dial
to the position and at the same time turn the
steam dial to the position. Hot water comes out
of the cappuccino maker.
4. To stop the ow of hot water, turn the steam dial to the 0
position and the mode selector dial to the l position.
You should not deliver hot water for more
than 60 seconds.
CLEANING
Cleaning the machine
The following parts of the machine must be cleaned regularly:
- the drip tray (A15);
- the coee lters (C2, C3 and C4);
- the boiler outlet (A13);
- the water tank (A1);
- the cappuccino maker (A7) as described in the section “Cle-
aning the cappuccino maker after every use”.
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the coee machine.
• Do not use metal objects to remove encrustations or coee
deposits as they could scratch metal or plastic surfaces.
Danger! Never immerse the coee maker in water. It is
an electrical appliance.
Please note:
If the appliance is not used for more than 3/4 days, before using it again, we strong-
ly recommend you perform a rinse cycle as described in the section “Setting up the
appliance”.
Cleaning the drip tray
Models ECP35.31 and 33.21: Important!
The drip tray is tted with a level indicator (red) showing the
level of water it contains.
Before the indicator protrudes from the cup tray (g. 25), the
drip tray must be emptied and cleaned, otherwise the water
may overow the edge and damage the appliance, the surface
it rests on or the surrounding area.
1. Remove the drip tray (g. 26).
2. Models ECP35.21 and 33.21: Remove the cup grille,
empty the water and clean the tray with a cloth, then reas-
semble the drip tray.
Extract the mugs or glasses tray (A14), clean with water,
dry and put back in the machine.
3. Put the drip tray back in place.
Cleaning the coee lters
Clean the coee lters regularly by rinsing under running water.
Make sure the holes are not blocked. If necessary, clean with a
pin (g. 27).
Cleaning the boiler outlet
About every 300 coees, the boiler outlet must be cleaned as
follows:
1. Make sure the appliance is not hot and that it is unplugged
from the mains;
2. Using a screwdriver, unscrew the screw xing the espresso
boiler outlet (g. 28);
3. Remove the boiler outlet;
4. Clean the boiler with a damp cloth (g. 28);
5. Clean the outlet thoroughly in hot water using a brush.
Make sure the holes are not blocked. If necessary, clean
with a pin.
6. Rinse under running water, rubbing all the time.
7. Replace the boiler outlet, making sure the gasket is cor-
rectly positioned.
Failure to clean as described above invalidates the guarantee.
Cleaning the water tank
1. Clean the water tank regularly (about once a month) and
whenever you replace the water softener lter (C7, *if
provided) with a damp cloth and a little mild washing up
liquid.
2. Remove the lter (*if present) and rinse with running
water.
3. Replace the lter (*if provided), ll the tank with fresh
water and replace the tank.
4. (Models with water softener lter only) Deliver about 100
ml of water.
DESCALING
You are recommended to descale the coee maker about every
200 coees.
We recommend using commercially available De’Longhi (C6*)
descaler.
Proceed as follows:
1. Fill the tank with the descaler solution, obtained by dilut-
ing the descaler with water following the instructions on
the pack.
2. Press the ON/OFF button.
3. Make sure the lter holder is not attached and place a re-
cipient under the cappuccino maker.
4. Wait until the OK light comes on.
5. Turn the mode selector dial to the position and
deliver about 1/4 of the solution in the tank. At intervals,
turn the steam dial to the
position to deliver
water from the cappuccino maker. Then interrupt delivery
by turning the mode selector dial to the l position and
leave the solution to work for about 5 minutes.
6. Repeat point 5 another 3 times, until the tank is empty.
7. To eliminate residues of descaler solution, rinse the tank
well and ll it with clean water (without descaler).
8. Turn the selector to the position and deliver
water until the tank is empty.
9. Repeat points 7 and 8.
TECHNICAL DATA
Mains voltage: 220-240V
˜
50/60Hz
Absorbed power: 1100W
Size LxDxH:
185x244(329)x305 mm
Pressure: 15 bar
Water tank capacity: 1.1 l
Power cord length: 1300 mm
Weight: 3,8 kg
The appliance complies with the following EC
directives:
• Stand-by European Regulation 1275/2008 and subsequent
amendments;
• Materials and accessories coming into contact with food
conform to European regulation 1935/2004.
DISPOSAL
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...