Loading ...
Loading ...
Loading ...
59
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Spots and filming
on dishes
Water hardness is too high. For extremely hard water, install
a water softener.
Dishes are loaded improperly. Reload the dishwasher as shown
in “Preparing and Loading
Dishes” on page 42.
Old or damp rinse aid power is
used.
Use fresh, liquid rinse aid.
The rinse aid dispenser is empty
or the setting is too low.
Fill the rinse aid dispenser.
Increase the rinse aid setting.
Etching Using too much detergent. Use less detergent if you have
soft water.
The inlet water temperature
exceeds 150° F.
Lower the inlet water
temperature.
Detergent left in
dispenser cup
Detergent may be too old. Use fresh detergent.
The spray arm is blocked. When you load the dishes, make
sure that the spray arms are not
blocked.
The detergent
dispenser will not
close
Improper operation of the
detergent cover.
Add detergent and rinse aid
only as indicated in this manual.
See “Filling the Detergent
Dispenser” on page 48 and
“Filling the Rinse Aid Dispenser”
on page 49.
Water remains in
the dishwasher.
The previous cycle has not
finished or has been interrupted.
Make sure that the current cycle
is finished.
The dishwasher
does not drain
properly.
The drain is clogged. Check the air gap (if so
equipped). Make sure that
the disposer is empty (if so
connected).
The drain hose is kinked. Make sure that the drain hose
is not kinked and is properly
connected.
TROUBLESHOOTING
Troubleshooting
Loading ...
Loading ...