Loading ...
Loading ...
Loading ...
Stopping an Alarm
Pressing any button while the beeper is
sounding stops it.
Determining an Alarm’s
On/Off Status
Turning on an alarm or the hourly time signal
causes the corresponding indicator to appear
on the display. The alarm on indicator is
displayed when one or more alarm is turned
on.
Hourly time signal
Alarm
Adjusting the Time
Setting Manually
When there is no communication with a
phone, the time and date can be adjusted with
the procedure below.
Getting Ready
Enter the Timekeeping Mode.
l
Navigating Between Modes
Setting the Time/Date
1. Hold down (A) for at least two seconds.
Release the button when [SET] stops
flashing.
2. Keep pressing (C) until the setting you
want to change is flashing.
●
Each press of (C) moves the flashing to
the next setting in the sequence shown
below.
Day
Month
Ye a r
Minute
Hour
Seconds
12/24-hour timekeeping
Illumination duration
Operation tone enable/disable
Daily step target
3. Configure the date and time settings.
●
To reset the seconds to 00: Press (D).
1 is added to the minutes when the
current count is between 30 and 59
seconds.
●
To change other settings: Use (D) and
(E).
4. Repeat steps 2 through 3 to configure date
and time settings.
5. Press (A) to exit the setting screen.
Switching Between 12-hour
and 24-hour Timekeeping
1. Hold down (A) for at least two seconds.
Release the button when [SET] stops
flashing.
2. Press (C) four times until the current
setting ([12H] or [24H]) is flashing on the
display.
3. Press (D) to toggle the setting between
[12H] (12-hour timekeeping) and [24H]
(24-hour timekeeping).
4. Press (A) to exit the setting screen.
Note
●
While 12-hour timekeeping is
selected, [P] will be displayed for p.m.
times.
Operation Guide 3464
16
Loading ...
Loading ...
Loading ...