Loading ...
Loading ...
Loading ...
Not for
Reproduction
16
4. Lower the cable cover into place.
5. Repeat the inspection procedure above. If the auger does not
rotate or does not stop as described, contact an authorized
service dealer to have the snowthrower inspected.
Access the Sparkplug
Toaccessthesparkplug,thesnowhoodmustberemovedas
follows:
1. TurntheON/OFFkey(A,Figure11)totheOFFpositionor
removethePush/Pullkey,ifequipped.
2. Grasp the choke control knob (B)andpulluptoremoveit.
3. Removethemountingscrewsorknobs(C)onthesnow
hood.
4. Lift the snow hood (D)othebaseandtiltitforward.Donot
disconnecttheprimerhose(E)orthekeyswitchwire(F).
5. Disconnectthesparkplugwire,thenremovethesparkplug(G)
to clean or replace it. See Specications.
6.Afterinstallingthesparkplug,connectthesparkplugwire.
7. Ensurethattheprimerhoseandkeyswitchwireareproperly
connected,thentthesnowhoodintothebaseandsecure
withthemountingscrewsorknobs.
8. Align the slots in the choke control knob with the tabs on the
choke shaft and push down to install. If the knob is not prop-
erly installed, the choke control will not operate.
A
B
C
Control Cable Adjustment
WARNING
Theaugermuststopwithin5secondsaftertheaugercontrolis
released. If it does not, adjust the control cable. See Adjust-
ment below or contact an authorized service dealer to adjust
the control cable.
Inspection
The auger should rotate only when the auger control is engaged
andmuststopwithin5secondswhentheaugercontrolis
released. If the auger does not rotate or does not stop as
described, adjust the control cable or contact an authorized
service dealer to adjust the control cable.
If the drive belt has broken, contact an authorized service dealer
to replace the belt and adjust the control cable.
Adjustment
1. Stoptheengineandremovethekey.SeeStop the Engine.
2. Lift the cable cover (A,Figure10)toexposetheadjustment
loops (B)andthecableendtting(C).
3. Removetheendttingfromtheadjustmentloopandreinstall
asfollows:
• If the auger rotates while the auger control is not
engaged, lengthen the control cable by installing
theendfittinginthenextlowestloop(decreasebelt
tension).
• If the auger does not rotate when the auger control is
engaged, shorten the control cable by installing the end
fittinginthenexthighestloop(increasebelttension).
NOTE: Someslackmustremaininthecablewhentheauger
control is not engaged.
A
C
E
B
D
F
G
10
11
Loading ...
Loading ...
Loading ...