Loading ...
Loading ...
3 ENGLISH
19.
Never use gasoline, benzine, thinner, alcohol or the like to clean the charger.
Discoloration, deformation or cracks may result.
FCC caution
Changes or modications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer
-
ence in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television recep
-
tion, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment
and receiver.
— Connect the equipment into an outlet on a cir-
cuit dierent from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV
technician for help.
Symbols
The followings show the symbols used for charger.
volts
amperes
hertz
alternating current
W
watt
direct current
Charging
CAUTION: After charging is complete, be
sure to remove the power plug of the battery
charger from the AC voltage source, and remove
the socket of the battery charger and attach the
cap of the battery.
NOTICE:
The battery charger is intended for charging
MAKITA portable power pack only. Never use it for
other purposes or for other manufacturer's batteries.
NOTICE:
When the battery charger is connected
to the unit, the tool or machine does not start. In
this case, remove the battery charger from the unit.
NOTICE:
If the temperature of the battery becomes
low or high during charging, the charging may stop.
In this case, wait until the battery becomes ordinary
temperature by warming up or cooling down the
battery, and then restart the charging.
1. Remove the cap of the battery by turning it.
1
► 1. Cap
2. Align the protrusion on the socket of the battery
charger with the counterpart on the plug of the unit, and
then attach the socket to the plug by turning the socket.
3 2
1
► 1. Protrusion 2. Socket 3. Plug
Loading ...
Loading ...
Loading ...