Loading ...
Loading ...
Loading ...
47
ADJUSTING THE SPEED SENSOR
ENGINEERING MODE MENU
The console has built in maintenance/diagnostic software.
The software will allow you to change the console settings
from English to Metric and turn o the beeping of the
speaker when a key is pressed for example. To enter the
Engineering Mode Menu, press and hold down the Start,
Stop and Enter keys. Keep holding the keys down for about
5 seconds and the Message Center will display Engineering
Mode Menu. Press the Enter key to access the menu below:
1. Key Test (Will allow you to test all the keys to make sure
they are functioning)
2. Display Test (Tests all the display functions)
If the calibration does not pass you may need to check the
speed sensor alignment.
1. Remove the motor cover hood by loosening the 4 screws
that hold it in place (you do not need to remove them
completely).
2. The speed sensor is located on the left side of the frame,
right next to the front roller pulley (the pulley will have
a belt around it that also goes to the motor). The speed
sensor is small and black with a wire connected to it.
3. Make sure the sensor is as close as possible to the pulley
without touching it. You will see a magnet on the face of
the pulley; make sure the sensor is aligned with the mag-
net. There is a screw that holds the sensor in place that
needs to be loosened to adjust the sensor. Re-tighten the
screw when nished.
3. Functions (Press Enter to access settings and Speed + or- arrow
to scroll)
• Sleep Mode (Turn on to have the console power down
automatically after 15 minutes of inactivity)
• Pause Mode (Turn on to allow 5 minutes of pause, turn o to
have the console pause indenitely)
• Maintenance (Reset lube message and odometer readings)
• Units (Sets the display to readout in English or Metric
display measurements)
• BEEP (After closing, there is no sound for key operation)
4. Child Lock (Allows you to lock the keypad so no unauthorized
use of the machine is allowed. When the child lock is enabled,
the console will not allow the keypad to operate unless you
press and hold the Child Lock buttons for 3 seconds to unlock
the console.)
5. Exit
Loading ...
Loading ...
Loading ...