Loading ...
Loading ...
Loading ...
ANTI-TIP DEVICE
3efore placing range in the counter, notice the
location of the stability bracket which is already
attached to the back of the range. This location
should work for most installations. However, it
may be more convenient to hook the stability
chain to the unit when the stability bracket is
attached to the upper set of holes in the back of
the range. See Fig. A. The upper level set of holes
are intended for use with a backsplash kit. If the
backsplash is not being used, make sure that there
are na structural suplx)rts for the countertop which
will interfere with the stability bracket when
located in the upper set of holes.
O
Backguard
Bracket
Optional
Bracket
Factory
Location
Mainback
2. Fasten onc end of
the stability chain to O Chain
7
the floor or wall with
the Ion_ screw and Washenra_l l
washer-supplied. See _.mw__
Fig. B. Make certain
the screw is going ..<'_x _
into the wall plate at
the ba._ of the wall or one of the studs in the ba_
of the wall. See Fig. C. Whether you attach the
chain to the wall or floor, be certain that the screw
is in at least 3/4 inch thickness of wood other than
baseboard and that there are no electrical wires or
plumbing in the area which the screw could
penetrate. Attach the stability chain in a location
which will allow the chain to be in line with the
bracket side to aide as much as possible when
attached to the unit. Test to see if the chain is
securely fastened by tugging on the chain.
O
I._g _crllw re _ _/,
Washer _6
I\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\ \\\\\\\\\\\\\\
3. Temporarily attachthe loose end of the chain
to the rear of the countertop with the tape from
the packaging. See Fig. D.
4. Place the range in the counter cutout leaving just
enough room between the back of the range and the
wallto reach the stability bracket.
5. Hook the loose end of the chain onto the bracket
by slipping the nearest linkof the chain into the
slot in the bracket. See Fig. A and make sure the
chain is pulled as tight as possible and that there
is no excess slack in the chain after the chain is
attached to the bracket.
A CAUTION: Excessive slack in the chain
could allow the range to tip over.
6. Slide the range all the way back into the counter.
Once the range is pushed back in place, there will
be a small amount of slack in the chain. This
is normal.
O
r---_l_._..Tape
NOTE:
• If attaching to masonry, you can buy suitable screws
and anchors at hardware stores. Use a masonry drill
to drill the required holes.
• If range is removed for cleaning or any other reason
make sure chain is reattached.
gl,
mlo
I
-1
mo
mmlo
35
Loading ...
Loading ...
Loading ...