GE - General Electric JGSP44AEV2AA GE gas slide-in range

User Manual - Page 15

For JGSP44AEV2AA.

PDF File Manual, 40 pages, Download pdf file

Loading ...
Loading ...
Loading ...
USING YOUR OVEN
,re Using Your Oven
1. l.ook at the controls. Be sure you understand
how to set them properly.
2. Check the oven interior. Lxmkat the shelves.
Take a practice run at removing and replacing them
properly to give sure, sturdy support.
3. Read over information and tips that follow.
4. Keep this guide handy so you can refer to it,
especially during the first weeks of using your
new range.
NOTE:
Youmay notice a "burning" or "oily" smell the
first few times you turn your oven on. This is normal
in a new oven and will disappear in a short time.
To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Operating the Self-
Cleaning Oven section.
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
Electric Ignition
The oven burner and broil burner are lit by
electric ignition.
To light either burner, touch the pad for the desired
function and press the INCREASE or DECREASE
pad until the desired temperature is displayed. The
burner should ignite within 30-90 seconds.
After the oven reaches the selected temperature, the
burner cycles--off completely, then on with a full
flame--to keep the oven temperature controlled.
Power Outage
CAUTION: DO NOT MAKE ANY ATrEMPT TO
OPERATE THE ELECTRIC IGNITION OVEN
DURING AN ELECTRICAL POWER OUTAGE.
Neither the oven nor the broiler can be lit during an
electrical power outage. Gas will not flow unless the
glow bar is hot.
If the oven is in use when a power outage occurs,
the oven burner shuts off and cannot be re-lit until
power is restored.
Oven Shelves
The shelves are designed with stop-locks so that
when placed correctly on the shelf supports, they
will stop before coming out completely from the
oven, and will not tilt when removing food from or
placing food on them.
When placing cookware on a shelf, pull the shelf out
to the bump on the shelf support. Place the eookware
on the shelf, then slide the shelf back into the oven.
This will eliminate reaching into the hot oven.
To remove the shelves from the oven, pull them
toward you, tilt front end upward and pull them out.
To replace, place the shelf on the shelf support with
the stop-locks (curved extension of the shelf) facing up
toward the rear of the oven. Tilt up the front and push
the shelf toward the back of the oven until it goes past
the bump on the shelf support. Then lower the front of
the shelf and push it all the way back.
(cmlthuwd nt'xt page)
Bum
?
,,-I=
"I
€t
15
Loading ...
Loading ...
Loading ...